CGS e.m. unit to Gilbert

The CGS e.m. unit of current (10 A) was inconveniently large for everyday lab work, while the CGS e.m. unit of resistance (the abohm, 10⁻⁹ Ω) was absurdly small. Physicists created "practical" units — the ampere, volt, and ohm — as decimal multiples that gave human-scale numbers. The ampere was set at 0.1 abampere. These practical units eventually became SI, while the "absolute" CGS units became historical footnotes.

In the 19th century, electricity and magnetism were treated as partially separate phenomena, leading to separate "natural" unit choices. The EMU system normalized magnetic permeability to 1; the ESU system normalized electric permittivity to 1; the Gaussian system mixed both. Once Maxwell unified electromagnetism, this fragmentation became unnecessary — but the systems persisted in literature for a century.

They introduced "practical" units — the ampere, volt, and ohm — as decimal multiples of CGS-EMU quantities. The ampere was defined as 0.1 abampere (CGS e.m. unit). This practical system eventually became SI, while the "absolute" CGS units faded. The factor of 10 was chosen for human-scale convenience.

The gauss (magnetic flux density, = 10⁻⁴ tesla) remains surprisingly common — refrigerator magnets are rated in gauss, and MRI field strengths are often quoted in both tesla and gauss. The oersted (magnetic field strength) appears in materials science. These CGS-EMU holdouts persist because their numerical values are more convenient for everyday magnets.

The SI was officially adopted in 1960, but the transition took decades. Most physics journals required SI by the 1970s, though astrophysics and plasma physics held onto Gaussian CGS into the 2000s. Some subfields never fully switched — you can still find new papers using gauss and oersted alongside tesla and A/m.

The gilbert equals 10/(4π) amperes because the CGS-EMU system uses a different form of Ampere's law where the factor 4π appears explicitly rather than being absorbed into μ₀. This "unrationalised" form distributes 4π differently in the equations, producing the 1/(4π) factor when converting to SI's "rationalised" system.

MMF is the magnetic analogue of voltage — it drives flux through a magnetic circuit the way EMF drives current through an electrical circuit. For a coil, MMF = N × I (turns times current). A 100-turn coil carrying 1 A has 100 ampere-turns of MMF. In CGS, that same MMF would be about 125.7 gilberts.

Gilbert (1544–1603) was physician to Queen Elizabeth I and author of De Magnete (1600), the first true scientific investigation of magnetism. He demonstrated that Earth is a magnet, distinguished magnetic from electrostatic attraction, and coined the word "electricus." He did all this 87 years before Newton's Principia — a genuine pioneer of experimental science.

Practically nowhere in new designs. You might encounter gilberts in vintage relay and transformer datasheets from the 1940s–1960s, in older American and European magnetic component catalogs, or in classic electrical engineering textbooks. Any modern magnetic circuit analysis uses ampere-turns (A·T) for MMF.

Multiply gilberts by 10/(4π) ≈ 0.7958 to get ampere-turns. Wait — that is backwards. Multiply gilberts by 0.7958 to get amperes for a single-turn coil. For MMF conversion: 1 gilbert = 0.7958 ampere-turns. So a relay spec of 5 Gi needs about 4 ampere-turns to actuate — for instance, 4 turns at 1 A or 8 turns at 0.5 A.