Mebibyte per second to Byte per second

dd uses binary units because Linux filesystems work in binary block sizes (4 KiB, etc.). Drive manufacturers use decimal MB/s because it makes speeds look about 5% higher and aligns with their decimal capacity marketing. A "550 MB/s" SSD shows roughly 524 MiB/s in dd.

Run "dd if=/dev/zero of=testfile bs=1M count=1024 oflag=direct" and it will report write speed in MiB/s. For read speed, use "dd if=testfile of=/dev/null bs=1M". The oflag=direct flag bypasses filesystem cache to measure actual disk performance.

No — 550 MiB/s is about 577 MB/s, and 550 MB/s is about 524 MiB/s. The ~5% difference means an SSD advertised at 550 MB/s will show around 524 MiB/s in Linux tools. It is not a defect or false advertising, just different unit systems measuring the same physical speed.

A RAID 0 stripe of two SATA SSDs gives roughly 1,000–1,100 MiB/s sequential reads. Four NVMe SSDs in RAID 0 can hit 12,000–14,000 MiB/s. RAID 5/6 arrays sacrifice some write speed for redundancy — expect 70–90% of raw stripe performance on writes.

Sequential reads let the drive stream data from contiguous locations, maximising throughput. Random I/O forces the controller to seek different addresses, adding latency per operation. An NVMe SSD might do 7,000 MiB/s sequential but only 50–80 MiB/s random (at 4 KiB block size), because the bottleneck shifts from bandwidth to IOPS.

Files are stored in bytes because CPUs address memory in byte-sized (8-bit) chunks — the smallest unit a program can read or write. Networks measure in bits because physical signals on a wire or fiber are serial: one bit at a time, clocked at a specific frequency. A 1 GHz signal produces 1 Gbps, not 1 GBps. The two worlds evolved independently and neither adopted the other's convention, leaving users to divide by 8 forever.

In modern computing, yes — a byte is universally 8 bits. Historically, some architectures used 6, 7, or 9-bit bytes, which is why the unambiguous term "octet" exists in networking standards. But for all practical bandwidth conversions today, 1 byte = 8 bits.

Network protocols add overhead — TCP headers, encryption (TLS), error correction, and packet framing all consume bandwidth without contributing to file data. A 100 Mbps connection might deliver 11 MB/s instead of the theoretical 12.5 MB/s because 10–15% goes to protocol overhead.

USB 3.0 has a theoretical maximum of 625 MB/s (5 Gbps ÷ 8), but real-world sustained transfers hit 300–400 MB/s due to protocol overhead and controller limitations. USB 3.2 Gen 2 doubles this to about 700–900 MB/s in practice.

The bit came first, coined by Claude Shannon in 1948. The byte was introduced at IBM in the mid-1950s by Werner Buchholz to describe the smallest addressable group of bits in the IBM Stretch computer. Originally it could be any size; the 8-bit byte became standard with the IBM System/360 in 1964.