BTU (IT)/hour to Terawatt

The classic rule: 20 BTU/h per square foot. A 300 sq ft bedroom needs about 6,000 BTU/h; a 500 sq ft living room about 10,000 BTU/h. But this varies wildly with sun exposure (+10% for south-facing), ceiling height, insulation quality, number of occupants (+600 BTU per person), and climate zone. A room above a pizza oven in Phoenix needs more than a basement in Seattle. When in doubt, oversize slightly — an undersized unit runs constantly and never reaches setpoint.

Undersizing is obvious — the unit runs constantly and never reaches the thermostat setpoint on hot days. But oversizing is worse in subtle ways. An oversized AC cools the air quickly then shuts off before removing enough humidity, leaving you with a clammy 72°F house. The short cycles also wear the compressor faster (startup is the hardest moment) and waste energy. A 1-ton oversize in a humid climate like Florida can raise indoor humidity from a comfortable 45% to a muggy 60%. Proper Manual J load calculations matter more than most homeowners realize.

By definition, one ton of refrigeration is exactly 12,000 BTU(IT)/h, giving approximately 3.517 kW of cooling power. The name comes from the historical cooling effect of melting a short ton of ice over 24 hours. That physical origin should not be confused with an exact claim about the latent heat of every ice sample; this converter uses the fixed International Table BTU relationship.

Modern units achieve 12–25 BTU/h per watt of electricity (SEER 12–25). A SEER 20 unit removes 20 BTU/h of heat for every watt consumed — effectively a 3:1 heat pump ratio. That 12,000 BTU/h window unit draws 500–1,000 W of electricity depending on efficiency. The best mini-splits achieve SEER 30+, removing 30 BTU/h per watt, making them cheaper to run than resistive electric heaters even in heating mode.

A gas furnace's BTU/h rating is its thermal output after combustion efficiency losses (typically 80–96% of fuel input). A heat pump's BTU/h rating is the heat delivered including energy moved from outside — at COP 3, a heat pump delivering 36,000 BTU/h uses only 12,000 BTU/h worth of electricity. This makes direct BTU/h comparisons misleading: a 60,000 BTU/h furnace and a 60,000 BTU/h heat pump deliver the same heat, but the heat pump uses one-third the energy.

The Sun delivers about 173,000 TW to Earth's surface. Human civilisation uses roughly 18 TW total. So we'd only need to capture 0.01% of incoming solar energy to power everything — an area of solar panels roughly 400 km × 400 km, about the size of Montana. The challenge isn't total energy availability; it's cost, storage, transmission, and the fact that sunlight is spread thin and intermittent.

Imagine 18 trillion light bulbs burning continuously, or 9 billion people each running a 2 kW heater non-stop. That 18 TW figure includes everything — electricity, transport fuel, industrial heat, cooking, heating. About 40% comes from oil, 27% from coal, 24% from gas, and the rest from nuclear and renewables. The US alone accounts for about 3 TW despite having only 4% of world population.

Replacing all 18 TW of human energy with clean sources would require roughly 60–75 TW of installed solar capacity (accounting for ~25% average capacity factor). That's about 40 times current installed solar. At 2023 installation rates of ~0.4 TW/year, it would take 150 years — but installation rates are doubling every 2–3 years. If that exponential trend holds, we could theoretically reach 60 TW of solar within 15–20 years.

Earth radiates about 47 TW of geothermal heat from its interior, driven by radioactive decay and residual primordial heat. That's 2.5× human energy consumption, but it's spread across the entire surface at extremely low density (~0.09 W/m²). Iceland, sitting atop a mantle plume, exploits geothermal for 90% of its heating. Globally, geothermal electricity capacity is only about 16 GW — a tiny fraction of what's theoretically available.

No — the terawatt scale is a very recent phenomenon. In 1800, global human power consumption was about 0.5 TW (mostly biomass burning). By 1900 it reached 1 TW with coal industrialisation. We crossed 10 TW around 1985. The jump from 1 to 18 TW in just 120 years tracks almost perfectly with global population growth times rising per-capita energy use. Pre-industrial humans used about 0.1 kW each; Americans now average 10 kW per person.