Joules/hour to Terawatt

When you're tracking energy budgets over hours — passive house heat loss, slow battery self-discharge, biological calorimetry — expressing rates in J/h matches the timescale of your measurements. A passive house losing 36 MJ/h is more intuitive to a building physicist than "10 kW" because they're calculating daily heat budgets in megajoules. It's a unit of convenience, not necessity.

One kWh = 3,600,000 J, so 3,600,000 J/h = 1 kW. The relationship is elegantly circular: if you consume 3.6 MJ/h of power, you use exactly 1 kWh of energy each hour. This makes J/h a natural bridge unit between the SI energy world (joules) and the practical electricity billing world (kWh). Multiply J/h by hours and you get joules of total energy; divide by 3,600,000 and you get kWh.

A Passivhaus-certified building targets heat loss below 54 MJ/h (15 W/m² × 1,000 m² for a typical house). A standard older home might lose 180–360 MJ/h (50–100 kW) on a cold day. The difference is dramatic: triple glazing, 300mm insulation, and air-tightness can reduce heat loss by 80%. Building energy certificates in some countries express this in kWh/m²/year, but the underlying calculation uses J/h or W.

About 230,000–290,000 J/h (65–80 W). This drops from your waking basal rate of ~290,000–360,000 J/h (80–100 W) because metabolic rate falls 10–15% during sleep. The heat warms your bed and room measurably — two people sleeping together can raise bedroom temperature by 1–2°C overnight in a small, well-insulated room. It's why you wake up warm even without the heating on.

Not directly — most building codes use watts per square meter (W/m²) or kWh/m²/year for energy performance ratings. However, the underlying heat transfer calculations in standards like ISO 13790 effectively compute in J/h when assessing hourly energy balances. Some German and Swiss engineering tools output intermediate results in kJ/h or MJ/h. The unit lives in the calculation layer, even if the final certificate uses more familiar units.

The Sun delivers about 173,000 TW to Earth's surface. Human civilisation uses roughly 18 TW total. So we'd only need to capture 0.01% of incoming solar energy to power everything — an area of solar panels roughly 400 km × 400 km, about the size of Montana. The challenge isn't total energy availability; it's cost, storage, transmission, and the fact that sunlight is spread thin and intermittent.

Imagine 18 trillion light bulbs burning continuously, or 9 billion people each running a 2 kW heater non-stop. That 18 TW figure includes everything — electricity, transport fuel, industrial heat, cooking, heating. About 40% comes from oil, 27% from coal, 24% from gas, and the rest from nuclear and renewables. The US alone accounts for about 3 TW despite having only 4% of world population.

Replacing all 18 TW of human energy with clean sources would require roughly 60–75 TW of installed solar capacity (accounting for ~25% average capacity factor). That's about 40 times current installed solar. At 2023 installation rates of ~0.4 TW/year, it would take 150 years — but installation rates are doubling every 2–3 years. If that exponential trend holds, we could theoretically reach 60 TW of solar within 15–20 years.

Earth radiates about 47 TW of geothermal heat from its interior, driven by radioactive decay and residual primordial heat. That's 2.5× human energy consumption, but it's spread across the entire surface at extremely low density (~0.09 W/m²). Iceland, sitting atop a mantle plume, exploits geothermal for 90% of its heating. Globally, geothermal electricity capacity is only about 16 GW — a tiny fraction of what's theoretically available.

No — the terawatt scale is a very recent phenomenon. In 1800, global human power consumption was about 0.5 TW (mostly biomass burning). By 1900 it reached 1 TW with coal industrialisation. We crossed 10 TW around 1985. The jump from 1 to 18 TW in just 120 years tracks almost perfectly with global population growth times rising per-capita energy use. Pre-industrial humans used about 0.1 kW each; Americans now average 10 kW per person.