Disintegrations per second to Gigabecquerel

Because dps is literally what the instrument measures — a detector counts individual nuclear decay events over time. Calling it "dps" keeps the language grounded in what physically happened. Calling it "Bq" applies an SI label to the same number. Old lab protocols, standard operating procedures written before 1975, and some US-centric equipment manuals still use dps because nobody rewrote the paperwork. Numerically, 1 dps = 1 Bq, so the conversion is trivially multiplying by one.

Counts per second (cps) is what the detector actually registers; disintegrations per second (dps) is how many decays actually occurred. No detector catches every decay — some radiation misses the detector, some is absorbed before reaching it, and some types of radiation are invisible to certain detectors. The ratio of cps to dps is the detection efficiency, which can range from under 1% (for low-energy beta emitters in a Geiger tube) to over 90% (for gamma emitters in a well counter). Getting from cps to dps requires careful calibration.

The sample is dissolved in a scintillation cocktail — a solvent containing fluorescent molecules. Each beta particle or electron excites the cocktail, producing a flash of light detected by photomultiplier tubes. But chemical impurities in the sample absorb some of that light (a phenomenon called quenching), so the counter sees fewer flashes than decays. The instrument runs an internal or external standard to measure the quench level, then applies a correction curve to convert raw cpm to true dpm, which you divide by 60 to get dps.

Not numerically — they are identical. But contextually, "dps" emphasizes the physical measurement process and appears in lab protocols where you are calculating detector efficiency: "the source emits 10,000 dps and the detector reads 3,200 cps, so efficiency is 32%." Writing that sentence with Bq would be technically correct but odd, like referring to your morning coffee temperature in kelvin. The unit name signals what kind of work you are doing.

Before the becquerel was adopted in 1975, there was no named SI unit for radioactivity — scientists just said "disintegrations per second" or used the curie. The CGPM gave the name "becquerel" to one disintegration per second to honor Henri Becquerel and to bring radioactivity into the SI naming system alongside the gray and sievert. The dps description never went away; it just lost its status as the primary label. Think of it like saying "cycles per second" instead of "hertz" — correct, but dated.

The patient swallows a capsule containing 1–7 GBq of I-131. The thyroid gland concentrates iodine from the bloodstream — it cannot tell radioactive iodine from stable iodine — so the isotope accumulates right where you want it. I-131 emits beta particles with a range of about 2 mm in tissue, which destroy thyroid cells from the inside while sparing nearby structures. The gamma rays it also emits are used for imaging to verify uptake. Within weeks the targeted tissue is dead, no scalpel required.

At 3–7 GBq, a freshly treated thyroid cancer patient is a walking radiation source. They emit gamma rays and excrete I-131 in sweat, saliva, and urine for days. Regulations typically require isolation until the retained activity drops below 1.1 GBq or the dose rate at 1 meter falls below 25 µSv/hr. That usually means 2–5 days of sleeping alone, using a dedicated bathroom, and avoiding prolonged close contact — especially with children and pregnant women, who are more radiation-sensitive.

Brachytherapy places a sealed radioactive source directly inside or next to a tumor — "brachy" is Greek for "short distance." High-dose-rate (HDR) sources of iridium-192 at 100–370 GBq deliver an intense, highly localized dose in minutes. The inverse-square law means tissue just centimeters away receives dramatically less radiation. This precision is why brachytherapy can treat cervical, prostate, and breast cancers with fewer side effects than external beam radiation alone.

Industrial radiography sources (1–20 GBq of Ir-192 or Se-75) live inside heavy shielded containers called "cameras" or "projectors" made of depleted uranium or tungsten. The source is only pushed out through a guide tube during an exposure, and the area is roped off with radiation monitors. Strict transport regulations, tamper-proof locks, and regular inventory audits apply. When sources decay below useful activity, they are returned to the manufacturer. The IAEA maintains a database of lost or orphaned sources — the ones that slip through the system occasionally cause severe accidents.

Diagnostic procedures use just enough activity to produce a readable image — typically 50–800 MBq (0.05–0.8 GBq). The goal is information, not tissue destruction. Therapeutic procedures aim to kill cells, so they use 10 to 100 times more: 1–7 GBq for thyroid ablation, 100–370 GBq for HDR brachytherapy sources. The line between them is roughly 1 GBq. Below that, you are taking a picture; above it, you are prescribing a lethal dose to a very specific target.